How do I change the chip on ink cartridges when the ink levels are low in the cartridge?

   

    In the printing process, many users will need to replace the ink cartridge chip. What should we do in this case? In particular, how to replace the chips on the cartridge when the ink is not enough?If you have any difficulty in replacing ink cartridge chips, there is no doubt that this text can help you.
1.Turn off your printer.
2.Remove the old ink cartridge from your printer.
3.Locate the smart chip, which will always be on the underside of the cartridge. You can do this by removing the plastic tabs securing the chip to the cartridge. Use a sharp, thin tool to do this, such as a Swiss army knife or utility knife. Slide the blade of the knife under one of the plastic tabs. Gently pry up. Repeat to remove the other plastic tab.
4.Lift the chip from the cartridge.
5.The new chip is placed on two plastic chips for fixing the chip to the ink cartridge.Gently    press down until the chip properly falls into place under the tabs. You can either use your index finger to do this or a pair of tweezers.
6.Place a tissue on a flat surface, such as a table or table. This is where you will be pouring the new ink into the empty ink cartridge. Place the empty cartridge on top of the paper towel, with the top of the cartridge facing up.
7.Read all the instructions in the manual included in your ink refill kit.

8.Locate the fill hole at the top of the old cartridge. You can feel the dent by rubbing your fingers at the top.
9.Pierce the refill hole -- check your refill manual, as some cartridges will have more than one refill hole -- with a sharp point, such as a needle or a thin pencil. The hole size should be minimal and the size of the long needle attached to the refill sublimation ink bottle.
10.Insert the long needle of the refill ink bottle into the correct ink hole on your cartridge. Try not to push any air into the cartridge while refilling. Very slowly and carefully, add the ink. Stop as soon as you see a bit of ink coming out of the hole.
11.Remove the needle completely.
12.Daub the top of the cartridge very lightly and carefully with the paper towel. A splotch of  ink should leak out onto the paper towel.
13.Tape the hole with a small piece of clear tape. Before putting the cartridge back in, make  sure that no ink is leaking out of the hole.
14.Insert the cartridge back into the printer.
15.Turn on your printer. It should now be showed as having full ink.The above is what  we share today. If you want to know more, you can pay attention to us. We will share our knowledge about the sublimation industry from time to time.

More info:
Website: www.skyimagepaper.com
Company Name: Fei Yue Digital Technology Co.,LTD
E-mail: sales@feiyuepaper.com 
Tel: 86-025-86628894
Whatsapp: +86 18252072197
Address: Central Road 323, Nanjing, Jiangsu, China